Currently the minimum burn time I can set in the Neje Control Software (V6.5.2) is 1mSec.
I have an E80 laser and I wish to use high laser power and very low burn time. (This should reduce total engraving time a lot)
I tried setting the burn time to 0.1mS for example but it changes back to 1mS
Can you please allow burn times of less than 1ms.
We will add this feature in a new version, this will take about 14 days or so, we will notify you when the feature is completed.
Thank you!
Hello Jack, Thanks for updating the software. I tried it today but there is a problem.
Although the laser pulse is shorter when you enter a burn time of less than 1mSec, the laser head still stays at each ‘pixel’ for the full 1mSec. So, when you reduce the burn time to less than 1mSec, the total job time is still the same as when it was set to 1mSec.
The aim of reducing the burn time to less than 1mSec is to reduce the total job time but you need to reduce how long the laser head stops as well as reducing the time the laser is pulsed on.
Are you able to fix this please?